Messer Cutting & Welding K4 Instrucciones de operaciones descargar pdf (Pagina 6)

Safety instructions

S / 1

For Your Safety

Observe accident prevention regulations.

Ignoring the following safety procedures can be fatal.

Designed use

This machine is manufactured according to the current state of the art and current regulations and

standards. It is to be operated only for the designed use (see Chap. Commissioning/Area of

application).

Use not as designed

This machine may be a hazard to persons, animals and property, however, if it is

· not used as designed

· used by unskilled persons who have not been trained

· modified or converted improperly

Our operating instructions will provide you with an introduction into the safe use of the

machine.

Therefore please read them closely and only start work when you are familiar with them.

Any person involved in operation, maintenance and repair of this machine must read and follow

these operating instructions, especially the safety precautions. Where appropriate, this must be

confirmed by signature.

Furthermore, the

· relevant accident prevention regulations,

· generally recognised safety regulations,

· regionally specific provisions etc. are to be adhered to.

· Before undertaking welding tasks, put on prescribed dry protective clothing, e.g. gloves.

· Protect eyes and face with protective visor.

Electric shocks can be fatal

· The machine may only be connected to correctly earthed sockets.

· Only operate with intact connection lead including protective conductor and safety

plug.

· An improperly repaired plug or damaged mains cable insulation can cause electric

shocks.

· The machine may only be opened by specialist staff.

· The unit must be disconnected from the mains power before being opened. Switching

off is not sufficient. Wait for 2 minutes until capacitors are discharged.

· Always put down welding torch, stick electrode holder in an insulated condition.

Even touching low voltages can cause you to get a shock and lead to accidents, so:

· Secure yourself from falls before working on platforms or scaffolding.

· When welding, operate earth tongs, torch and workpiece properly, not in ways for

which they are not intended. Do not touch live parts with bare skin.

· Only replace electrodes when wearing dry gloves.

· Never use torches or earth cables with damaged insulation.

1 2 3 4 5 6 7 8 9 10 11 ... 89 90

Sin comentarios

Messer Cutting & Welding K4 Instrucciones de operaciones Pagina 6