Messer Cutting & Welding K4 Instrucciones de operaciones descargar pdf (Pagina 51)

6 Commissioning

6/1

6.1 Range of applications:

• MIG/MAG welding (only in combination with an additional wire feed unit) for

steel-CrNi ∅ 0.8mm to 1.6mm,

aluminium ∅ 1.0mm to 1.6mm and

cored wires ∅ 0.9mm to 1.2mm.

6.1.1 Proper usage

These welding machines are only suitable for MIG/MAG welding.

Any other use is regarded as "improper" and no liability is assumed for any damage arising

therefrom.

We can only guarantee smooth and trouble-free operation of the machines when used in

conjunction with the welding torches and accessories from our range.

6.2 Setting up the welding machine

Follow the safety instructions on the opening pages entitled "For Your Safety".

Set up the machine so that there is sufficient space to adjust the operating elements.

Ensure that the machine is set up in a stable position and appropriately secured.

6.3 Mains connection

The correct mains plug must be connected to the mains supply lead on the machine. The

connection must be made by an electrician in compliance with current VDE regulations.

The phase sequence is irrelevant and has no effect on the direction of rotation of the fan

and pump, where applicable.

For mains fuse protection, please refer to the technical data (chapter 1).

• Insert mains plug of the switched-off machine into the appropriate socket.

6.3.1 Reconnecting the mains voltage 400/415V on the control transformer

The Faston plug (arrow) must be set on the transformer according to the mains voltage.

(Factory setting 400V.)

The following labels are located at the rear of the machine (top nameplate) (e.g.: factory

setting 400)

400V

Netzanschluß-

spannung

Mains voltage

The current mains voltage configuration for the machine is given on this label.

Sample labels with special voltages are included with

each machine (see right).

If the mains voltage configuration is changed, the

corresponding label with the new mains voltage printed

on it must be affixed over the sticker (right-hand box) on

the rear of the machine.

230V 230V

400V 400V

415V

440V/460V

400V/415V

460V

500V 500V

___V ___V

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 89 90

Comentarios a estos manuales

Sin comentarios

Messer Cutting & Welding K4 Instrucciones de operaciones Pagina 51

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Messer Cutting & Welding K4